NDT Inspection Plug


& TML / UT Point Technical Data

 

NDT Inspection Plugs

  • 50 Durometer EPDM
  • Ethylene Propylene Rubber
  • Chemical Resistance: Excellent
  • Ozone, Water/Steam Resistance: Excellent
  • Permanent Set Resistance: Excellent
  • Temperature Range:-65°F (-54°C) to +300°F (+149°C) for Continuous Operation.
    Note: Silicone Sleeves available for higher (400°f) operating temps.
  • Tensile Strength: 1400 PSI
  • Elongation: 300%
  • ASTM D2000 2BA, 510, A14, B13, C12, F17
  • OSHA 29 CFR 1910.119/261 (Monitor Process Equipment)
  • API 510/570/653 (Inspection Codes)
  • API RP 578/579/581
  • US Patent #5,014,866

TDS for NDT Inspection Plugs

” . . .a specification refers to a set of documented requirements

to be satisfied by a material, design, product, or service.”

'DO NOT REMOVE"

TDS for TML / UT Point Labels

TML / UT Point Labels

Thickness Measurement Location (TML) and Ultrasonic Testing (UT) point labels are constructed with:

  • 3.5 mil matte silver mylar polyester material with a 1.0 mil UV laminate. The matte coating resists degradation from scuffing, chemicals, moisture and wide temperature fluctuations.
  • High-performance acrylic adhesive for excellent bonding to metals, HSE plastics and a wide variety of painted & textured surfaces.
  • Low-leachable chloride, fluoride and sulfur is in the adhesive.
  • Typical values for continuous temperature resistance range between -40°F (-40°C) and 300°F (149°C). The minimum application temperature is 58°F.