NDT Plug Installation

NDT Insulation Inspection Plug

Locate and mark the insulation jacket where the inspection port will be installed:

Hole saws are best to penetrate the insulation jacket, cutting a circumference equal to the Inspection port to be installed.
Use either tin snips or a hole saw to penetrate the insulation jacket with a circumference equal to the size of the NDT Inspection Plug to be installed.
Remove the insulation, to expose the substrate for inspection.
After inspection, re-insert the insulation or replace it with a high-density material.
Insert the EPDM or Silicone Sleeve.
Install the Inspection Port Locking Ring and Lanyard if equipped.
Insert the Port Cap to create a seal.

Note: Caulking around sleeve for cold applications installations recommended